Table 3-5. Signal Type Group Choices - Thermo Scientific 5028i Instruction Manual

Operation
Instrument Controls Menu
Choose Signal to Output
3-46 Model 5028i Instruction Manual
The Choose Signal to Output screen displays a list of the analog
output signal choices. Choices are grouped into three categories:
Concentrations, Other Measurements, and Analog Inputs (if the I/
O expansion board option is installed). This allows the user to select
the output signal that will be assigned to each analog channel. The
Concentrations screen is shown below. See
for each signal group choice.
In the Main Menu, choose Instrument Controls > I/O
l
Configuration > Analog Output Config > select Channel > Choose
Signal to Output.
CHOOSE SIGNAL TYPE:
>CONCENTRATIONS
OTHER MEASUREMENTS
ANALOG INPUTS
RANGE
CHOOSE SIGNAL -
SELECTED OUTPUT:
CURRENTLY: PM
RANGE
Note The Analog input config screen is visible only when the I/O
expansion board option is installed and the service mode is on . For
more information on the service mode, see
"Program Versions Voltages".
Table 3–5. Signal Type Group Choices
Concentrations Other Measurements
None None
PM Barometer Pressure
AVG PM Vacuum
Flow Pressure
Ambient RH
Sample RH
Ambient Temp
Board Temp
AVG DIAGS ALARM
SET TO: NONE
CHANGE VALUE
AVG DIAGS ALARM
s
Analog Inputs
None
Analog Input 1 (if the I/O expansion board
is installed)
Analog Input 2 (if the I/O expansion board
is installed)
Analog Input 3 (if the I/O expansion board
is installed)
Analog Input 4 (if the I/O expansion board
is installed)
Analog Input 5 (if the I/O expansion board
is installed)
Analog Input 6 (if the I/O expansion board
is installed)
Analog Input 7 (if the I/O expansion board
is installed)
Table 3–5 for a list of items
CONC
V1
?
SAVE
"Service Mode" earlier in
Thermo Fisher Scientific