Thermo Scientific 5028i Instruction Manual page 293

Thermo Fisher Scientific
instr name
This command reports the instrument name. The following example
reports the instrument name for the Model 5028i.
Send: instr name
Receive: instr name
Beta
Particle Analyzer
instrument id
This command reports the instrument identification (ID). The following
example reports the current setting of the instrument ID.
Send: instrument id
Receive: instrument id 14
set instrument id value
This command sets the instrument ID to value, where value is an
integer between 0 and 127 inclusive. The following example shows the
instrument ID changed to 12.
Note Sending this command via RS-232 or RS-485 will require the
host to use the new ID for subsequent commands.
Send: set instrument id 12
Receive: set instrument id 12 ok
layout ack
This command reports the stale layout/layout change indicator (*) that
is attached to each response if the erec layout has changed since the last
time erec layout was requested, according to
example reports that the instrument is configured to do nothing.
Send: layout ack
Receive: layout ack 0
set layout ack value
This command disables the stale layout/layout change indicator (*) that
is attached to each response if the erec layout has changed since the last
time erec layout was requested, according to
Send: set layout ack
Receive: set layout ack ok
C-Link Protocol Commands
Communications Configuration
s
Table B–9. The following
Table B–9.
Model 5028i Instruction Manual B-53