Thermo Scientific 5028i Instruction Manual page 92

Operation
Instrument Controls Menu
Default Gateway
3-38 Model 5028i Instruction Manual
Netmask
The Netmask screen is used to edit the netmask. The netmask is
used to determine the subnet on which the instrument can directly
communicate to other devices. The netmask can only be changed when
DHCP is off. If DHCP is on, the instrument will respond with "NOT
SETTABLE IF DHCP IS ON". For more information on DHCP, see
"Use DHCP" above.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > TCP/IP Settings > Netmask.
The Default Gateway screen is used to edit the gateway address. The
default gateway can only be changed when DHCP is off. If DHCP is
on, the instrument will respond with "NOT SETTABLE IF DHCP
IS ON". For more information on DHCP, see
Any traffic to addresses that are not on the local subnet will be routed
through this address.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > TCP/IP Settings > Gateway.
The Host Name screen is used to edit the host name. When DHCP is
Host Name
enabled, this name is reported to the DHCP server.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > TCP/IP Settings > Host Name.
NETMASK:
CURRENT: 255.255.252.0
SET TO: 255.255.254.0 0
MOVE CURSOR
CHANGE VALUE
SAVE VALUE
RANGE AVG DIAGS ALARM
DEFAULT GATEWAY:
CURRENT: 10.209.42.1
SET TO: 10.68.178.1
MOVE CURSOR
CHANGE VALUE
SAVE VALUE
RANGE AVG DIAGS ALARM
HOST NAME:
CURRENT: ISERIES
ISERIES
ABCDEFGHIJKLMN
OPQRSTUVWXYZ
0123456789 ./-
RANGE AVG DIAGS ALARM
"Use DHCP" above.
SSSSS ?
BKSP
PAGE
SAVE
Thermo Fisher Scientific