Thermo Scientific 5028i Instruction Manual page 87

RS-232/RS-485 Selection
RS-232/RS-485 SELECT:
XXXXXX** WARNING
DISCONNECT THE
CABLES BEFORE CHANGING
THE
RANGE
Instrument ID
Gesytec Serial Number
Thermo Fisher Scientific
The RS-232/RS-485 Selection screen allows the user to choose between
the RS-232 or RS-485 specification for serial communication.
Equipment Damage Disconnect the serial cable before changing the
RS-232 and RS-485 selection to prevent damage to any equipment
currently connected to the analyzer.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > Serial Settings > RS-232/485 Selection.
**XXXXXXX
SERIALX X
SELECTION!XXXXXX
TO CONTINUE
AVG DIAGS ALARM
The Instrument ID screen allows the operator to edit the instrument
ID number. The ID is used to identify the instrument when using
the C-Link or MODBUS protocols to control the instrument or
collect data. It may be necessary to edit the ID number if two or
more instruments of the same model are connected to one computer.
Valid instrument ID numbers are from 0 to 127. The Model 5028i
has a default instrument ID of 28. For more information about the
instrument ID, see Appendix B
Appendix C
In the Main Menu, choose Instrument Controls > Communication
l
Settings > Instrument ID.
The Gesytec Serial Number screen is used to set the serial number for
the Gesytec protocol. The Gesytec serial number defaults to zero. For
more information about the serial number, see Appendix D, "Gesytec
(BH) Protocol".
In the Main Menu, choose Instrument Controls > Communication
l
Settings > Gesytec Serial No.
RS-232/RS-485 SELECT:
CURRENTLY:
SET TO:
X MAKE SURE THAT THE
IS OFF: PRESS
RANGE AVG
"C-Link Protocol
"MODBUS Protocol".
INSTRUMENT ID:
CURRENTLY:
SET TO:
RANGE AVG
Instrument Controls Menu
s
RS-232
RS-485 ?
CABLEXX
TO CONFIRM
TOGGLE VALUE
DIAGS ALARM
Commands" or
28
28 ?
CHANGE VALUE
SAVE VALUE
DIAGS ALARM
Model 5028i Instruction Manual
Operation
3-33