UNIVERGE SV9100
System Hardware Manual
1.1.2.1
Connector Pin-Out on the GPZ-BS10/GPZ-BS11
Table 3-1 GPZ-BS10/GPZ-BS11 Connector Pin-Out
1.1.2.2
Install the GPZ-BS10 Expansion Base Blade in the
CHS2UG Controlling Chassis
Figure 3-6 GPZ-BS10 Components
1.
Ensure the chassis is powered down.
2.
Locate the door positioned on the left end (expansion bay) of
the Controlling Chassis (refer to
Expansion Bay in Controlling Chassis on page
RJ-61 Cable Connector
GPZ-BS10 – CN2, CN3, CN 4
GPZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with the
power on.
Figure 3-7 GPZ-BS10
Issue 1.2
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
3-6).
3 - 5