Installing Into The Universal Slot - NEC SL2100 Quick Install Manual

Install the 3COIDB Card

Installing into the Universal Slot

Remove the plastic knockout from the slot on the front of the SL2100 chassis.
Any universal slot can be used, it is recommended that you install the cards using slot order 1->4. Slots are
identified S1~S4 on the front of the chassis.
Note – The knockout can not be replaced once removed; there are no blanking covers available, be sure to
remove the correct knockout.
Note – Slot 4 does not support digital extensions.
Insert the interface card into the SL2100 universal slot, ensure the card slides into the guide rails and tighten the
two screws to secure the card.
The type of trunk daughter card installed can be identified by the RJ45 sockets visible on the front of the
interface card.
Quick Install Guide – SL2100 with Analogue Trunks rev 1.1
11