Suzuki SY413 Service Manual page 1901

7A2-10 MANUAL TRANSMISSION
1. Steering knuckle 3. Link nut
2. BaIl stud bolt 4. Lower arm
1. Drive shaft
joint
2. Screwdriver
2. Center bearing support
1. Drive shaft joint 3. Bolts
1. Differential side oil seal
DIFFERENTIAL SIDE OIL SEAL
REPLACEMENT
1) Lift up vehicle and drain transmission oil.
2) Remove ball stud bolt and link nut, and then separate suspen-
sion arm from knuckle.
3) D In case of left side oil seal:
By using large size screwdrivers, pull out drive shaft joint so
as to release snap ring fitting of joint spline at differential side.
Pushing knuckle portion outward, detach drive shaft at differ-
ential side.
D In case of right side oil seal:
Remove exhaust No.1 pipe.
By using plastic hammer, drive out drive shaft joint so as to
release snap ring fitting of joint spline at center shaft.
After removing center bearing support bolts, pull out center
drive shaft from differential gear.
4) Remove oil seal and install a new one by using special tool and
hammer.
NOTE:
When installing oil seal, face its spring side inward.
Special Tool
(A): 09913-75810
Distance "a": 1.0 – 1.5 mm (0.04 – 0.06 in.)
5) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal contacts and make sure of its smoothness.
"A": SUZUKI SUPER GREASE A, 99000-25010