Suzuki SY413 Service Manual page 1427

REMOVAL
WARNING:
Failure to follow the following procedure and WARNING
may cause air bag deployment, personal injury, damage
to parts, or air bag being unable to deploy.
D Never rest a steering column assembly on steering
wheel with air bag (inflator) module face down and col-
umn vertical.
D When handling the air bag (inflator) modules (driver
and passenger), be careful not to drop it or apply an im-
pact to it. If an excessive impact was applied (e.g.,
dropped from a height of 91.4 cm (3 feet or more), nev-
er attempt disassembly or repair but replace it with a
new one.
D When grease, cleaning agent. oil, water, etc. has got
onto air bag (inflator) modules (driver and passenger),
wipe off immediately with a dry cloth.
1) Disconnect negative (–) cable at battery.
2) If equipped with air bag, disable air bag system. Refer to "Disab-
ling Air Bag System" in SECTION 9J.
3) Drain engine coolant and disconnect water hoses from heater
unit.
4) Remove instrument panel, refer to "INSTRUMENT PANEL" at
SECTION 9.
1. Heater hose
5) Remove rear duct. (If equipped).
6) Remove heater unit.
1. Bolt
2. Nut
7) Remove heater unit clips and screws to separate heater unit.
1. Screw
HEATER AND VENTILATION 1A-11