Suzuki SY413 Service Manual page 1623

1. Suspension frame
1. No.2 control rod
2. Suspension frame
1. Used clamp 2. Tire lever
ON-VEHICLE SERVICE
REMOVE AND INSTALL SUSPENSION FRAME
REMOVAL
1) Hoist vehicle and remove wheels (right and left).
2) Drain differential oil.
3) For vehicle equipped with ABS, detach ABS wheel speed sen-
4) Remove rear drive shaft nut of left side.
2. Fuel tank
5) To facilitate toe adjustment after reinstallation, put match marks
6) Loosen No.2 control rod outer bolts (right and left) and remove
7) Remove No.1 control rods (right and left).
3. Washer
4. Match marks
8) Remove left drive shaft from differential and knuckle, and dis-
sor connector and harness (right and left) from suspension
frame and control rod.
on washer and on suspension frame (right and left).
No.2 control rod (inner) bolts (right and left).
connect right drive shaft from differential.
REAR SUSPENSION (4WD VEHICLE) 3E1-3
1. Suspension frame
2. No.1 control rod
3. No.2 control rod
4. Differential
5. Differential mounting
6. Differential mounting bracket