Suzuki SY413 Service Manual page 1607

REMOVE AND INSTALL WHEEL HUB
(WHEEL BEARING) ASSEMBLY AND WHEEL
STUD (HUB BOLT)
Wheel bearing and wheel hub form a solid unit.
When wheel bearing is found defective and its replacement is nec-
essary, replace hub assembly.
REMOVAL
1) Hoist vehicle and remove brake disc or brake drum referring to
SECTION 5.
2) Remove spindle cap as shown (by hammering lightly at 3 loca-
tions around it so as not to deform or cause damage to seating
part of cap).
1. Spindle cap
2. Wheel hub
3) Uncalk spindle nut and remove spindle nut and washer.
1. Spindle cap
2. Spindle (axle)
nut
3. Washer
4. Wheel hub
4) Pull wheel hub off by using special tools.
Special Tool
(A): 09943-17912
(B): 09942-15511
1. Wheel hub
5) Remove hub bolts.
Refer to FRONT WHEEL STUD REMOVAL in SECTION 3D in
the Service Manual mentioned in FOREWORD of this manual
for removal procedure.
1. Wheel hub
2. Bearing
3. Hub bolt
REAR SUSPENSION (2WD VEHICLE) 3E-15