Suzuki SY413 Service Manual page 2260

1. Power wrench
2. Flange
3. 36 mm nut (Spare parts No. 09159-28002)
4. Flange bolt
5. Spring balance (1 – 5 or 1 – 10 kg range)
6. Flange
1. Bearing outer race
1. Bearing outer race
2. Differential case
13) Install flange to bevel pinion and tightening flange nut gradual-
ASSEMBLING UNIT
1) Install side oil seal to bearing outer race.
2) Place bearing outer races on their respective bearings.
3) After applying differential oil to side bearings, install case as-
3. Differential carrier
4) Tighten bearing retainer.
ly with special tool and power wrench to specified torque while
turning bevel pinion.
Set preload of bevel pinion to specification.
NOTE:
D Before taking measurement with spring balance, check
for smooth rotation by hand.
D Be sure to tighten gradually and carefully till specified
starting torque is obtained. Turning back overtightened
flange nuts should be avoided.
Special Tool
(C): 09922-75222
(F): 09930-40113
Tightening Torque
(a): 200 N·m (20.0 kg-m, 145.0 lb-ft)
Pinion bearing preload: 5 – 13 kg-cm (4.4 – 11.2 lb-in)
Starting torque with special tool: 1 – 2.6 kg (2.2 – 5.7 lb)
Then apply grease to oil seal lip.
"A": Grease 99000-25010
Special Tool
(A): 09913-75520
NOTE:
Used left and right outer races are not interchangeable.
sembly in carrier.
Special Tool
(B): 09923-58520
REAR DIFFERENTIAL 7F-13