Suzuki SY413 Service Manual page 2395

9-26 BODY SERVICE
BACK WINDOW (For Sedan Model)
Back window glass is installed by using a special type of adhesive
(that is, one component urethane adhesive used with primer). For
back window glass replacement, it is important to use an adhesive
which provides sufficient adhesion strength and to follow the prop-
er procedure.
CAUTION:
Described here is the glass replacement by using one
component urethane adhesive to be used with primer
in combination. Each adhesive has its own drying and
setting time and must be handled and used in a certain
specific procedure. Negligence in the following such
procedure or misuse of the adhesive in any way hin-
ders its inherent adhesive property. Therefore, before
the work, make sure to read carefully the instruction
and description given by the maker of the adhesive to
be used and be sure to follow the procedure and ob-
serve each precaution throughout the work.
Should coated surface be scratched or otherwise
damaged, be sure to repair damaged part, or corrosion
may start from there.
Use an adhesive of above mentioned type which has the following
property.
Shearing strength: 40 kg/cm
Adhesive materials and tools required for removal and installation.
One component urethane adhesive and primers used in com-
bination (For one sheet of window glass).
Adhesive (260 g (9.2 oz.))
Primer for glass (20 g (0.7 oz.))
Primer for body (20 g (0.7 oz.))
Primer for urethane (molding) (20 g (0.7 oz.))
Eyeleteer
Piano string
Brush for primer application (3 pcs.)
Knife
Rubber sucker grip
Sealant gun (for filling adhesive)
Putty spatula (for correcting adhered parts)
NOTE:
Wear gloves when removing and installing glass.
Use care not to cause damage to heating wire for defroster
(if equipped).
2 2
(569 Ib/in ) or more