Suzuki SY413 Service Manual page 1927

7A2-36 MANUAL TRANSMISSION
1. Differential side R bearing
2. Differential case
3. Differential side L bearing
1. Final gear bolts 3. Soft jawed vise
2. Final gear
1. Reverse gear shaft
2. Right case
1. REV gear
2. REV gear shift
lever
3. Washer
4) Install speedometer drive gear, and then install circlip.
5) Press-fit R bearing by using special tools and copper hammer.
6) Hold differential assembly with soft jawed vise, install final gear
ASSEMBLING UNIT
LEFT CASE
1) For installation procedure, refer to Steps 3) and 4) of Differential
2) Make reverse idler gear with reverse gear shift lever, insert re-
3. Reverse idle gear
A: Align with B
3) For installation procedure, refer to Steps 6) to 8) of Differential
4) Install another case bolts from clutch housing side and tighten
Special Tool
(A): 09924-74510
(B): 09951-16060
(C): 09913-85230
and bevel gear and then tighten them with 10 bolts to specified
torque.
CAUTION:
Use of any other bolts than specified ones is prohib-
ited.
Thread lock cement
"A": 99000-32030 (SUZUKI BOND No. 1303B)
Tightening Torque
(a): 73 N·m (7.3 kg-m, 53.0 lb-ft)
to Left Case in Section 7A (ASSEMBLING UNIT).
verse gear shaft into case through idler gear and then align A
in shaft with B in case.
NOTE:
D Make sure that washer has been installed in shaft at
above the gear.
D Check to confirm that reverse gear shift lever end has
clearance 1 mm (0.04 in.) to idler gear groove.
to Left Case in Section 7A (ASSEMBLING UNIT).
them to specification.