Suzuki SY413 Service Manual page 2137

7B1-84 AUTOMATIC TRANSMISSION
1. Drive plate bolt
2. Transmission case
3. Cylinder block
1. Drive shaft joint
2. Tire lever
<J18 engine model>
1) Disconnect negative cable at battery and transmission.
2) Disconnect coupler for solenoids, vehicle speed sensor (for
speedometer), transmission range sensor, forward clutch cyl-
inder revolution sensor and output shaft speed sensor.
3) Undo wiring harness clamps.
4) Disconnect select cable from transmission.
5) Remove transmission-to-engine bolts.
6) Remove starting motor.
Starting motor plate should also come down.
7) Support engine to prevent one from being declined excessive-
ly at removal of mounting supports.
8) Check around transmission for any other parts required to be
removed or disconnected for dismounting of transmission and
remove or disconnect whatever necessary.
9) Drain transmission fluid.
10) Remove engine under covers.
11) Disconnect fluid (oil) cooler hoses.
12) Remove mounting member.
13) Remove transmission housing lower plate.
14) Holding drive plate with a proper size rod against rotation, re-
move drive plate bolts.
15) Pull out left drive shaft joint at differential and right drive shaft
joint at center shaft so as to release snap ring fitting.
16) Disconnect stabilizer joints from suspension arms on both
sides.
17) Remove ball stud bolts and nuts from both knuckles and de-
tach suspension arms and then pull out left drive shaft joint
from differential and right drive shaft joint from center shaft.
18) Remove center shaft from differential.
19) Remove engine rear mounting and its bracket bolts at trans-
mission case.
20) Remove engine-to-transmission bolt and nut.