Suzuki SY413 Service Manual page 2207

7B1-154 AUTOMATIC TRANSMISSION
1. Speedometer driven gear (Vehicle speed sensor for
speedometer) shaft sleeve subassembly.
1. Transmission range sensor
2. Bolt
5. Manual shift lever
76) Coat new O-ring with A/T fluid.
77) Tighten speedometer driven gear (vehicle speed sensor for
speedometer) (with new O-ring installed) with bolt.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 Ib-ft)
78) Install transmission range sensor assembly.
a) Place new rubber plate and new lock washer or transmis-
b) Tighten lock nut.
c) Adjust transmission range sensor.
d) Tighten transmission range sensor bolts.
e) Tighten manual shift lever with spring washer and nut.
4. Lock nut
3. Lock washer
79) Install oil cooler pipes.
1. Oil cooler pipe
2. New gasket
Tightening Torque
(a): 27 N·m (2.7 kg-m, 19.5 lb-ft)
(b): 18 N·m (1.8 kg-m, 13.0 lb-ft)
NOTE:
Make sure to use new A/T fluid pipe union bolt gaskets to
prevent fluid from leaking.
80) Measure starting torque of differential gear assembly.
For detail, refer to step 2) on "UNIT DISASSEMBLY" proce-
dure.
sion range sensor.
Tightening Torque
(a): 7.0 N·m (0.7 kg-m, 5.0 lb-ft)
Tightening Torque
(b): 20 N·m (2.0 kg-m, 14.5 Ib-ft)
Tightening Torque
(b): 20 N·m (2.0 kg-m, 14.5 lb-ft)