Suzuki SY413 Service Manual page 2191

7B1-138 AUTOMATIC TRANSMISSION
8) Place check balls, oil solenoid strainer, check valves and com-
pression springs to rear valve body.
Check Valve Spring Identification
1. Check ball
2. Check ball (large)
3. Oil strainer
4. Check valve
(spring 1)
5. Check valve
(spring 2)
6. Rear valve body
9) Place gaskets and plate on rear valve body.
NOTE:
Place new gaskets and plate as shown in figure, that is,
"A0" mark provided on plate faces to front valve body
side.
1. Rear valve body
2. Gasket
3. Plate
10) Place check valve and compression spring to front valve body.
1. Check valve
2. Compression spring
3. Front valve body
11) Install rear valve body with gaskets, plate and inner parts to
front valve body and tighten bolts to specified torque.
Tightening Torque
(a): 6.8 N·m (0.68 kg-m, 4.9 lb-ft)
Free length
Spring g
mm (in.) mm (in )
1 12.6 (0.496) 5.2 (0.205) 5.3 (0.209)
2 18.1 (0.713) 6.2 (0.244) 7.0 (0.276) Yellow Yellow
Outside diameter Identification
mm (in.)
G16 J18 G16
Blue
color
J18
Light
blue