Suzuki SY413 Service Manual page 2142

1. Torque converter 2. Converter housing
1. Differential pinion shaft
2. Differential pinion
UNIT DISASSEMBLY
CAUTION:
Thoroughly clean transmission exterior before over-
hauling it.
Keep working table, tools and hands clean while over-
hauling.
Use special care to handle aluminum parts so as not
to damage them.
Do not expose removed parts to dust. Keep them clean
always.
1) Extract torque converter.
CAUTION:
Remove torque converter as much straight as pos-
sible. Leaning it may cause to damage oil seal lip.
2) Measure starting torque of differential gear assembly using
special tool.
Special Tool
(A): 09928-06050
Specified value
(a): 1.0 – 1.4 N·m (0.1 – 0.14 kg-m, 0.74 – 1.0 lb-ft)
NOTE:
Record actual starting torque of differential assembly for
installation reference.
3) Remove oil cooler pipes.
NOTE:
Never reuse gaskets after removal.
1. Oil cooler pipe
2. Gasket
AUTOMATIC TRANSMISSION 7B1-89