Suzuki SY413 Service Manual page 1683

4A-8 FRONT DRIVE SHAFT
1. Wheel side joint assembly
2. Wheel side boot band
3. Wheel side boot
4. Boot band
5. Differential side boot
6. Differential side boot band
7. Tripod joint spider
8. Circlip
9. Tripod joint housing
10. Snap ring
A: Black grease (about 70 g/2.5 oz)
B: Yellow grease (about 95 g/3.4 oz)
C: Chamfered spline
D: Forward rotation
E: Clamp band this way
7) Facing its chamfered spline inward (wheel side), then fasten it
with circlip.
Special Tool
(A): 09900-06107
8) Fill up differential side boot inside with grease, then install hous-
ing and joint it with boot.
9) Fasten boot with bands.
1. Spider
2. Bearing
3. Circlip
CAUTION:
D To prevent any problem caused by washing solution,
do not wash joint boots and tripod joint except its
housing.
Degreasing of those parts with cloth is allowed.
D To ensure full performance of joint as designed, be
sure to distinguish between two types of grease in re-
pair set and apply specified volume to respective joint,
i.e. black grease (130 g tube) to wheel side joint and
yellow one (130 g tube) to tripod joint.
D Band each boot band against forward rotation.
D Do not squeeze or distort boot when fastening it with
bands.
Distorted boot caused by squeezing air may reduce its
durability.