Suzuki SY413 Service Manual page 1557

3C1-10 AIR BAG STEERING WHEEL AND COLUMN
Turn slowly till coil stops.
Turn contact coil back about 2 and a half
turns.
1. Align marks.
1. Lugs
2. Grooves
3. Alignment marks
3) Turn contact coil counterclockwise slowly with a light force till
contact coil will not turn any further.
NOTE:
Contact coil can turn about 5 turns at maximum, that is, if
it is at the center position, can turn about two and a half
turns both clockwise and counterclockwise.
4) From the position where contact coil became unable to turn any
further (it stopped), turn it back clockwise about two and a half
rotations and align center mark with alignment mark.
INSTALLATION
1) Check that vehicle's front tires are at straight-ahead position
and contact coil is centered. Refer to "Centering Contact Coil"
earlier in this section.
CAUTION:
These two conditions are prerequisite for installation
of steering wheel. If steering wheel has been installed
without these conditions, contact coil will break when
steering wheel is turned.
2) Install steering wheel to steering shaft with 2 lugs on contact coil
fitted in two grooves in the back of steering wheel and also align-
ing marks on steering wheel and steering shaft.
3) Tighten steering shaft nut to specified torque.
Tightening Torque
(a): 33 N·m (3.3 kg-m, 23.5 lb-ft)
4) Install air bag (inflator) module to steering wheel. Refer to "Driv-
er Air Bag (Inflator) Module" earlier in this section.
5) Connect negative battery cable.
6) Enable air bag system. Refer to "Enabling Air Bag System" un-
der "Service Precautions" earlier in this section.