Suzuki SY413 Service Manual page 1909

7A2-18 MANUAL TRANSMISSION
1. 5th gear spacer
2. L bearing (Install it first)
INPUT SHAFT ASSEMBLY
Disassembly
1) Remove input shaft R bearing spacer and circlip.
2) For disassembly procedure, refer to Steps 2) to 7) of same item
in Section 7A.
Inspection and Reassembly
1) For inspection and reassembly procedure, refer to Steps 1) to
4) of same item in Section 7A.
2) Drive in R bearing spacer by using special tool and hammer.
Special Tool
(A): 09913-80112
3) Install circlip to input shaft.
4) For inspection and reassembly procedure, refer to Steps 6) to
8) of same item in Section 7A.
1. R bearing
spacer
2. Input shaft
5) Press-fit L bearing by using special tool and hammer.
Special Tool
(A): 09913-80112
6) Using the same special tool, drive in 5th gear spacer.
CAUTION:
To prevent 5th gear spacer from being distorted be-
cause of excessive compression, do not press-fit it
with L bearing at once.