Suzuki SY413 Service Manual page 1431

D Fresh Air Control (FRESH-CIRC Selector) Cable
– Move control lever to "CIRCULATION" position as full as pos-
sible.
– Push lever fully in arrow direction and fix cable with clamp in
position as shown.
D After installing control cables, be sure that control knobs move
smoothly and stop at proper position.
MODE CONTROL SWITCH
REMOVAL
1) Disconnect negative (–) cable battery.
2) If equipped with air bag, disable air bag system.
Refer to "Disabling Air Bag System" in SECTION 9J.
3) Pull of control lever knobs.
4) Remove center garnish mounting screw.
5) Remove center garnish with mode control switch.
1. Mounting screw
2. Center garnish
6) Remove mode control switch from center garnish.
1. Mode control switch
HEATER AND VENTILATION 1A-15