Suzuki SY413 Service Manual page 1414

0B-18 MAINTENANCE AND LUBRICATION
4-speed A/T
1. Radiator
2. Inlet hose (Outlet from oil cooler)
3. Outlet hose (Inlet to oil cooler)
1. UPPER level
2. LOWER level
[Fluid cooler hose change]
Replace inlet and outlet hoses of cooler hose and their clamps.
For replacement procedure, refer to ON-VEHICLE SERVICE in
SECTION 7B or 7B1.
ITEM 6-9
All Hinges, Latches and Locks Inspection
Doors
Check that each door of front, rear and back doors opens and
closes smoothly and looks securely when closed.
If any malfunction is found, lubricate hinge and latch or repair door
lock system.
Engine hood
Check that secondary latch operates properly (check that second-
ary latch keeps hood from opening all the way even when pulling
hood release handle inside vehIcle.) Also check that hood opens
and closes smoothly and properly and hood locks securely when
closed.
If any malfunction is found, lubricate hinge and latch, or repair hood
lock system.
"A": Oil point
1. Upper hinge
2. Lower hinge
3. Door
4. Body
ITEM 6-10
Power Steering (P/S) System Inspection (If equipped)
1) Visually check power steering system for leaks or damage.
2) Check fluid level with engine stopped.
If it is lower than LOWER level, fill fluid up to UPPER level.
NOTE:
D Fluid level should be checked when fluid is cool.
D Be sure to use specified power steering fluid.
3) Visually check pump drive belt for cracks and wear.
4) Check belt for tension, referring to ITEM 1-1 of "ENGINE" in this
section. If necessary, have belt adjusted or replaced.