Suzuki SY413 Service Manual page 2143

7B1-90 AUTOMATIC TRANSMISSION
1. Transmission
range sensor
2. Manual shift lever
3. Lock nut
4. Lock washer
5. Bolt
1. Oil level gauge
2. Oil filler tube
3. Output shaft speed sensor
4. Input shaft speed sensor
5. Vehicle speed sensor (for speedometer)
4) Pull out transmission range sensor assembly.
a) Remove manual shift lever.
b) Pry off lock washer.
c) Remove lock nut.
d) Remove lock washer and rubber plate.
e) Remove 2 bolts.
NOTE:
Never reuse lock washer after removal.
5) Remove oil level gauge, oil filler tube, output shaft speed sen-
sor, input shaft speed sensor and vehicle speed sensor (for
speedometer).
6) Remove transmission housing by removing 15 bolts as shown.
NOTE:
Never reuse removed 2 bolts (1).
7) Pull out differential gear assembly.
8) Clean and wipe off gasket sealer on mating surface between
transmission housing and transmission case.
9) Remove three gaskets at transmission case side.
NOTE:
Never reuse removed gaskets.