Suzuki SY413 Service Manual page 1626

3E1-6 REAR SUSPENSION (4WD VEHICLE)
1. Outside inner race
2. Wheel hub
1. Brake drum
2. Drive shaft nut
3. Calked
INSTALLATION
1) Install hub bolts.
Refer to FRONT WHEEL STUD INSTALLATION in SECTION
3D for installation procedure.
2) Install outside inner race to wheel hub using special tool.
Installing direction is as shown.
Special Tool
(E): 09940-53111
3) Apply grease to outside bearing, outside inner race and oil seal
lip.
"A": Grease 99000-25010
4) Install wheel hub to knuckle by tightening drive shaft nut. Do not
tap wheel hub.
5) Install brake drum referring to BRAKE DRUM INSTALLATION
in SECTION 5.
6) Pull up parking brake lever fully and tighten new drive shaft nut
to specified torque.
Tightening Torque
(a): 175 N·m (17.5 kg-m, 126.5 lb-ft)
7) Calk drive shaft nut.
WARNING:
Be careful while calking nut so that no crack will occur
in calked part of nut. Cracked nut must be replaced
with new one.
8) Install wheel and lower hoist.
9) Perform brake test.