Suzuki SY413 Service Manual page 1824

5B-40 ANTILOCK BRAKE SYSTEM (ABS)
1. Console box
2. G sensor
FORWARD
G SENSOR (IF EQUIPPED)
REMOVAL
1) Turn ignition switch to OFF position.
2) Remove console box extension (right and left).
3) Disconnect connector from sensor.
4) Remove sensor with bracket from floor.
INSPECTION
"A" : Power source
"B" : Signal
1) Check sensor bracket for bend.
"C" : Ground
2) Connect positive cable of 12 volt battery to "A" terminal of sen-
sor and ground cable to "C" terminal. Then using voltmeter,
check voltage between "B" terminal and "C" terminal.
When placed horizontally: 2 – 3 V
When placed upright with arrow upward: 3 – 4 V
When placed upright with arrow downward: 1 – 2 V
– Horizontal If measured voltage is not as specified, replace sensor with
bracket.
– Upright with
– arrow upward
– Upright with
– arrow downward
INSTALLATION
1) Using new screws, install sensor with bracket onto floor so that
arrow mark directs vehicle forward.
2) Connect connector to sensor securely.
3) Install console box extensions.
1. Arrow mark
CAUTION:
D Do not separate sensor and bracket. It will lead to
erroneous assembly.
D Sensor must not be dropped or shocked. It will af-
fect its original performance.