Suzuki SY413 Service Manual page 1405

1.3L and 1.6L Engine model
1.8L Engine model
1. FULL level mark 3. Tank cap
2. LOW level mark 4. Match marks
ITEM 1-5
Engine Coolant Change
WARNING:
To help avoid danger of being burned, do not remove ra-
diator cap while engine and radiator are still hot. Scald-
ing fluid and steam can be blown out under pressure if
cap is taken off too soon.
1) Remove radiator cap when engine is cool.
2) Loosen radiator drain plug to drain coolant.
3) Remove reservoir tank and drain.
4) Tighten drain plug securely. Also install reservoir tank.
5) Fill radiator with specified amount of coolant, and run engine for
2 or 3 minutes at idle. This drives out any air which may still be
trapped within cooling system. STOP ENGINE. Add coolant as
necessary until coolant level reaches filler throat of radiator. Re-
install radiator cap.
1. Radiator
2. Radiator drain plug
6) Add coolant to reservoir tank so that its level aligns with Full
mark. Then, reinstall cap to reservoir tank aligning match marks
on the tank and cap.
Refer to SECTION 6B of this manual for COOLANT CAPACITY
ITEM 1-6
Exhaust System Inspection
WARNING:
To avoid danger of being burned, do not touch exhaust
system when it is still hot.
Any service on exhaust system should be performed
when it is cool.
CAUTION:
When changing engine coolant, use mixture of 50%
water and 50% ethylene-glycol base coolant (Anti-
Freeze/Anti-corrosion coolant) for the market where
ambient temperature falls lower than –165C (35F) in
winter and mixture of 70% water and 30% ethylene-
glycol base coolant for the market where ambient
temperature doesn't fall lower than –165C (35F).
Even in a market where no freezing temperature is an-
ticipated, mixture of 70% water and 30% ethylene-gly-
col base coolant should be used for the purpose of
corrosion protection and lubrication.
MAINTENANCE AND LUBRICATION 0B-9