Suzuki SY413 Service Manual page 2045

7B-106 AUTOMATIC TRANSMISSION (3 A/T)
A > B, a < b
1. 2nd brake accumulator
2. 2nd brake accumulator springs
47) Check second brake piston stroke as previously described.
For checking procedure, refer to step 12) of "DISASSEMBLY"
in this section.
48) Install second brake band cover with new gasket.
Tightening Torque
(h): 8 N·m (0.8 kg-m, 6.0 Ib-ft)
49) Install oil pressure control cable in case.
50) Install accumulator springs and pistons.
i) Install new seal rings on pistons, if required.
Be sure to apply automatic transmission fluid to pistons
and seal rings.
ii) Insert springs into accumulator bores.
NOTE:
Install 2nd brake accumulator springs as shown in left
figure.
iii) Install pistons into case.
iv) Install spring into 2nd brake accumulator piston.