Suzuki SY413 Service Manual page 1602

3E-10 REAR SUSPENSION (2WD VEHICLE)
1. Suspension frame
2. Suspension frame cap
3. No.1 control rod
4. No.2 control rod
1. No.1 control rod
2. No.2 control rod
3. Outer bolt
4. Inner bolt and No.2 control rod bolt
5. Nut
6. Washer
7. Match marks
8. Welded nut
5) Remove suspension frame cap.
6) Remove No.2 control rod from suspension frame and knuckle.
7) Remove No.1 control rod from suspension frame and knuckle.
INSTALLATION
1) Install No.1 control rod.
i) Install No.1 control rod, setting it so that its welded nut comes
toward the rear.
ii) Insert inner and outer bolts from the vehicle front and tighten
them temporarily by hand.
2) Install No.2 control rod.
i) Install No.2 control rod, setting it so that its welded nut comes
toward the front.
ii) Insert No.2 control rod bolt from the vehicle front and outer
bolt from the rear.
iii)Install washer with its graduated part facing down.
iv)With marks on washer and frame marked before removal
aligned to each other, tighten bolts and nut temporarily by
hand.