Suzuki SY413 Service Manual page 2257

7F-10 REAR DIFFERENTIAL
DRIVE BEVEL PINION
To engage bevel pinion and gear correctly, it is prerequired to install bevel pinion to differential carrier properly by
using adjusting shim as described on following pages. Shown in this page are relative positions of bevel pinion,
differential carrier and mounting dummy.
A: Pinion dummy height
B: Mounting dummy height
C: Measured dimension
D: Differential carrier mounting distance (A + B + C)
E: Bevel pinion mounting distance
(Marked in shaft in mm)
F: Shim size for mounting distance adjustment
(D – E)
1. 36 mm nut (Spare parts No.09159-28002)
2. Flange
3. Front bearing
4. Rear bearing
5. Differential carrier
6. Drive bevel pinion nut
7. Front case
8. Spacer
9. Bevel pinion
10. Bevel gear
Special Tool
(A): 09900-20606
(B): 09922-77280
(C): 09922-75222