Suzuki SY413 Service Manual page 2173

7B1-120 AUTOMATIC TRANSMISSION
1. Align plate
1. Reverse clutch drum
2. Sun gear input flange
3) Remove snap ring of reverse clutch drum with bearing.
1. Reverse clutch
drum subassembly
with bearing
2. Snap ring
4) Install sun gear input flange (thrust washer installed) with retain-
er ring.
5) Mount reverse clutch drum with bearing to oil pump body.
6) Measure piston stroke with compressed air (400 – 800 kPa, 4
– 8 kg/cm
cial tools.
Special Tool
(A): 09900-20606
(B): 09900-20701
Specified piston stroke: 0.932 – 1.608 mm (0.037 – 0.633 in.)
NOTE:
D To prevent air leakage from oil hole section "A" during
pack clearance measurement with air nozzle gun, it is
recommended to plug oil hole section around air nozzle
gun with a clean cloth or the like because pack clearance
cannot be measured otherwise.
D If it is difficult to obtain correct specified value above, it
is recommended to align plate (Thickness: approximate-
ly 3 mm) with shape around oil hole section.
DISASSEMBLY
1) Remove reverse clutch drum with bearing from oil pump body.
2) Remove sun gear input flange with thrust washer installed by
removing retainer ring.
3. Thrust washer
4. Retainer ring
2
, 57 – 113 psi) through oil hole section "A", using spe-