Suzuki SY413 Service Manual page 2399

9-30 BODY SERVICE
BACK DOOR GLASS
(For Hatch-back and Wagon Models)
Back door glass is installed by using a special type of adhesive
(that is, one component urethane adhesive used with primer). For
back door glass replacement, it is important to use an adhesive
which provides sufficient adhesion strength and to follow the prop-
er procedure.
CAUTION:
Described here is the glass replacement by using one
component urethane adhesive to be used with primer in
combination. Each adhesive has its own drying and set-
ting time and must be handled and used in a certain spe-
cific procedure. Negligence in the following such
procedure or misuse of the adhesive in any way hinders
its inherent adhesive property. Therefore, before the
work, make sure to read carefully the instruction and de-
scription given by the maker of the adhesive to be used
and be sure to follow the procedure and observe each
precaution throughout the work.
Use an adhesive of above mentioned type which has the following
property.
Shearing strength: 40 kg/cm
Adhesive materials and tools required for removal and installation.
One component urethane adhesive and primers used incom-
bination (For one sheet of window glass).
Adhesive (250 g (8.8 oz.))
Primer for glass (20 g (0.7 oz.))
Primer for body (20 g (0.7 oz.))
Primer for urethane (molding) (20 g (0.70 oz.))
Eyeleteer
Piano string
Brush for primer application (3 pcs)
Knife
Rubber sucker grip
Sealant gun (for filling adhesive)
Putty spatula (for correcting adhered parts)
2 2
(569 Ib/in ) or more