Suzuki SY413 Service Manual page 1517

3B1-20 POWER STEERING (P/S) SYSTEM
[1.8 L engine model]
1. Engine rear mounting
2. Mounting bracket
3. Mounting member
4. Suspension frame
5. Exhaust pipe rear stiffener
[1.3 L and 1.6 L engine models]
[1.8 L engine model]
1. High pressure pipe
2. Low pressure hose
3. Cylinder pipe "A"
4. Cylinder pipe "B"
8) [1.8 L engine model]
6. Rear mounting bracket
No.2
7. Rear mounting bracket
8. Transmission case
9. Engine oil pan
9) Remove cylinder pipe "A" and "B" from steering gear box, us-
10) Disconnect high and low pressure pipes from steering gear box,
11) Remove steering gear box mounting bolts and then remove
INSTALLATION
Reverse removal procedure for installation of steering gear box noting
the following points.
D If a plug was put to disconnected pipe when removing steering gear
i) Remove engine under cover (both sides), exhaust pipe
No.2 and mounting member.
ii) Remove exhaust pipe rear stiffener.
iii) Remove engine rear mounting bracket No.2 with engine
rear mounting bracket from engine block and transmission
case.
ing flare nut wrench.
NOTE:
As fluid flows out of disconnected joints, put a receptacle
under joints or a plug to pipe.
using flare nut wrench.
NOTE:
As fluid flows out of disconnected joints, have a container
under joints or a plug to pipe.
steering gear box from vehicle.
CAUTION:
Be sure to confirm that steering wheel and front tires
(wheels) are in straight position when inserting steering
lower joint into steering pinion shaft.
box, remove that plug before reconnecting pipe.