Suzuki SY413 Service Manual page 2238

1. Boot 4. Piston spring
2. Push rod 5. Cup retainer
3. Piston assembly 6. Cylinder
REASSEMBLY
NOTE:
Before installation, wash each part in specified brake fluid.
1) Apply brake fluid to inside of piston assembly and cylinder body.
2) Install piston assembly into cylinder.
3) With piston pushed down, install circlip as shown.
4) Install boot.
1. Circlip
2. Push rod
CLUTCH OPERATING CYLINDER
DISASSEMBLY
7. Bleeder
screw
1) Remove boot and then push rod.
1. Hole for hose
connection
2) Remove piston by blowing compressed air into bolt hole where
2. Piston
3. Cylinder
hose was connected, using care to prevent it from jumping out.
INSPECTION
Inspect all disassembled parts for wear or damage, and replace
parts if necessary.
NOTE:
D Wash disassembled parts with brake fluid.
D Do not reuse piston cups.
Inspect cylinder bore for scoring or corrosion.
It is best to replace corroded cylinder. Corrosion can be identified
as pits or excessive roughness.
CLUTCH (HYDRAULIC TYPE) 7C1-13