Suzuki SY413 Service Manual page 1862

1. Hub plate
2. Circlip
3. Shift fork plug
A: Pin slit (Face outward)
1. 5th to REV interlock guide bolt
2. Gear shift guide case
3. Gear shift case plate bolt
A: Breather (Air blow)
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-37
13) Drive in spring pin facing its slit A outward.
14) Install steel ball, tighten shift fork plug applied with thread lock
cement.
"A": Thread lock 1322, 99000-32110
Tightening Torque
(c): 9 N·m (0.9 kg-m, 6.5 lb-ft)
15) Fit hub plate and fix it with circlip.
CAUTION:
D Coat shift fork plug with thread lock cement rea-
sonably. If it is done to much, excess may interfere
in ball movement and cause hard shift to 5th
speed.
D Make sure circlip is installed in shaft groove se-
curely.
16) Clean mating surface of both left case and side cover, coat
mating surface with sealant evenly, mate it with left case and
then tighten with 8 bolts.
"B": Sealant 99000-31110
Tightening Torque for left cover bolts:
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
1. Side cover
2. Left case
GEAR SHIFT & SELECT SHAFT ASSEMBLY
1) If gear shift guide case has been disassembled or replaced,
tighten bolts as specified below. Also check breather hole for
clog.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
2) Clean mating surface of guide case and coat it with sealant
evenly.
"A": Sealant 99000-31110