Suzuki SY413 Service Manual page 1551

3C1-4 AIR BAG STEERING WHEEL AND COLUMN
1. Junction/fuse block
2. Yellow connector of driver air bag (inflator) module
3. Yellow connector of passenger air bag (inflator) module
4. Glove box
ENABLING AIR BAG SYSTEM
1) Turn ignition switch to "LOCK" and remove key.
2) Connect Yellow connector of passenger air bag (inflator) mod-
ule and Yellow connector of driver air bag (inflator) module re-
spectively, and be sure to lock each connector with lock lever.
Fit each air bag (inflator) module connector onto each connec-
tor stay.
3) Install glove box and steering wheel side cap.
4) Install "AIR BAG" fuse to the junction/fuse block.
5) Turn ignition switch to "ON" and verify that "AIR BAG" warning
lamp flashes 6 times and then turns off.
If it does not operate as described, perform "Air Bag Diagnostic
System Check" in SECTION 9J.
HANDLING PRECAUTIONS
Live (Undeployed) Air Bag (Inflator) Module (Driver and
Passenger)
WARNING:
Never attempt to measure the resistance of the air bag
(inflator) modules (driver and passenger). It is very dan-
gerous as the electric current from the tester may deploy
the air bag.
Special care is necessary when handling and storing a live (unde-
ployed) air bag (inflator) module. The rapid gas generation pro-
duced during deployment of the air bag could cause the air bag
(inflator) module, or an object in front of the air bag (inflator) mod-
ule, to be thrown through the air in the unlikely event of an acciden-
tal deployment.
D Never attempt disassembly of the air bag (inflator) module.
D If any abnormality is found, be sure to replace it with new one as
an assembly.
D When an abnormality is noted as existing in the live (unde-
ployed) air bag (inflator) module, be sure to deploy it before dis-
carding it. (Refer to "Air Bag (Inflator) Modules Disposal" in
SECTION 9J.)