Suzuki SY413 Service Manual page 2024

COUNTERSHAFT AND OUTPUT SHAFT
Countershaft Bearings
Removal
1) Remove snap rings by using a screwdriver.
2) Remove backing plate (rear cover side).
3) Remove front and rear counter shaft bearings.
i) Using special tools (Bearing remover and sliding shaft), re-
move bearing.
ii) Remove other side of bearing in the same way.
Special Tool
(A): 09941-64511
(B): 09930-30104
Installation
A: For countershaft
bearing
1) Install countershaft bearing (Roller bearing) to case.
Use special tools (Bearing installer attachment and installer
handle).
The bearing installer attachment has two sides.
Use small side A for installation of countershaft bearings.
Special Tool
(A): 09924-74510
(B): 09926-88310
AUTOMATIC TRANSMISSION (3 A/T) 7B-85
1. Countershaft 7. Bearing backing plate
2. Output shaft 8. Snap ring
3. Snap ring 9. Reduction driven gear
4. Roller bearing 10. Reduction driven gear nut
5. Spacer 11. Output shaft seal ring
6. Ball bearing 12. Output shaft bearing