Suzuki SY413 Service Manual page 1667

4-4 FRONT DRIVE SHAFT
1. Drive shaft nut
A: Undo caulking
1. Knuckle
2. Ball stud bolt and nut
1. Center shaft
2. Center bearing support
REMOVAL (Right Side Shaft)
ON FLOOR
Undo caulking and remove drive shaft nut and washer.
ON LIFT
1) By using plastic hammer, drive out drive shaft joint so as to re-
1. Drive shaft joint
2. Center bearing support
2) Disconnect stabilizer joint from suspension arm.
3) Remove ball stud bolt, and then separate suspension arm from
3. Suspension arm
4) To remove drive shaft assembly, pull out inboard joint from cen-
5) Drain transmission oil.
6) Loosen center bearing support bolts and remove center shaft
lease snap ring fitting of joint spline at center shaft.
knuckle.
ter shaft and then wheel side joint from steering knuckle.
CAUTION:
To prevent breakage of boots, be careful not to bring
them into contact with other parts, when removing
drive shaft assembly.
from differential side gear.