Suzuki SY413 Service Manual page 1762

5-68 BRAKES
1. Retainer
2. Reservoir
[Other than 1.8L engine RH model]
1) When using new grommets, lubricate them with the same fluid
as the one to fill reservoir with. Then press-fit grommets to mas-
ter cylinder. Grommets must be seated in place.
2) Install reservoir on master cylinder with pin or bolt.
NOTE:
when inserting pin, drive till both of its ends at the right and
left of reservoir become the same length.
1. Reservoir
2. Pin
3) Install EVAP canister to its bracket, if removed.
4) Connect reservoir lead wire.
5) Fill reservoir with special fluid.
6) Upon completion of installation, check for fluid leakage.
REMOVE AND INSTALL MASTER CYLINDER
RESERVOIR
REMOVAL
NOTE:
Do not allow brake fluid to get on painted surfaces.
[1.8L engine RH model]
1) Remove master cylinder. Refer to "REMOVAL" under "RE-
MOVE AND INSTALL MASTER CYLINDER ASSEMBLY" in this
section.
2) Remove retainer as shown.
3) Remove reservoir.
1. Master cylinder
2. Reservoir
3. O-ring