Suzuki SY413 Service Manual page 1510

[1.3 L and 1.6 L engine models]
[1.8 L engine model]
1. P/S fluid reservoir 4. P/S gear box
2. Gauge valve (open) 5 High pressure side
3. P/S pump 6 Low pressure side
1. P/S fluid reservoir 4. P/S gear box
2. Gauge valve (open) 5. High pressure side
3. P/S pump 6. Low pressure side
HYDRAULIC PRESSURE IN P/S CIRCUIT
1) After cleaning joint of high pressure hose and P/S pump thor-
oughly, disconnect hose from pump and install special tool (oil
pressure gauge, attachment and hose).
Tighten each flare nut to specified torque.
CAUTION:
Take care not to causes damage to A/C condenser
during service operation, if equipped.
Special Tool
(A):09915-77410 (Oil pressure gauge)
(B):09915-77420 (Attachment & hose) (For 1.3 L and 1.6 L
engine models)
(C):09945-36010 (Attachment & hose) (For 1.8 L engine
model)
2) Check each connection for fluid leakage and bleed air.
(Refer to AIR BLEEDING PROCEDURE.)
3) With engine idling, turn steering wheel and warm up engine till
temperature of fluid in tank rises to 50 – 605C (122 – 1405F).
4) Check back pressure by measuring hydraulic pressure with en-
gine idling and hands off steering wheel.
Back pressure: Lower than 1000 kPa (10 kg/cm
When back pressure is higher than specified values, check con-
trol valve and piping for clogging.
POWER STEERING (P/S) SYSTEM 3B1-13
2
, 142 psi)