Suzuki SY413 Service Manual page 2007

7B-68 AUTOMATIC TRANSMISSION (3 A/T)
1. Transmission case housing
1. Second brake
band pin
1. Direct clutch
2. Input shaft
1. Direct clutch
2. Input shaft
15) Remove oil pump.
i) Remove 6 oil pump securing bolts.
ii) Remove oil pump by using special tool.
CAUTION:
Make sure that 2nd brake piston and piston rod
have been removed before oil pump removal. If
not, they may cause breakage of 2nd brake band.
Special Tool
1. Oil pump
(B): 09918-48210
16) Remove transmission case housing.
i) Remove housing internal bolts and external bolts.
ii) Remove housing while tapping around it lightly with a plas-
tic hammer.
17) Remove second brake band pin.
18) Remove direct clutch and forward clutch at the same time
while holding input shaft.
NOTE:
Be careful not to loose ring gear race and bearing which
may sometimes stick to input shaft.
19) Remove direct clutch assembly from input shaft.
20) Remove second brake band.