Suzuki SY413 Service Manual page 1666

1. Drive shaft nut
A: Undo caulking
1. Drive shaft joint (LH)
2. Screwdriver
1. Knuckle
2. Ball stud bolt and nut
3. Suspension arm
REMOVAL (Left Side Shaft)
ON FLOOR
Undo caulking and remove drive shaft nut and washer.
ON LIFT
1) Drain transmission oil.
2) By using large size screwdrivers, pull out drive shaft joint so as
to release snap ring fitting of joint spline at differential side.
3) Disconnect stabilizer joint from suspension arm.
4) Remove ball stud bolt, and then separate suspension arm from
knuckle.
5) To remove drive shaft assembly, pull out inboard joint from dif-
ferential side and then wheel side joint from steering knuckle.
CAUTION:
To prevent breakage of boots, be careful not to bring
them into contact with other parts, when removing
drive shaft assembly.
FRONT DRIVE SHAFT 4-3