Chrysler Conquest 1988 Service Manual page 95

BODY
- Front Door Glass and Regulator
23-67
I I II III
2.0 (.8) I
Thickness:
I I
1 LO4)
mm (in.)
SERVICE POINTS OF REMOVAL
1. REMOVAL OF DOOR TRIM
Refer to P.23-64.
2. REMOVAL OF WATERPROOF FILM
Cut away the non-drying adhesive around the waterproof
film with a cutter or similar tool.
Caution
If the clip for the door trim is still in the mounting hole
in the body, remove it with the tool shown in the
illustration.
3. REMOVAL OF DOOR DRIP MOULDING / 4. DOOR BELT
MOULDING / 5. DOOR WINDOW REAR SASH MOULD-
ING
Insert the trim stick at the position of the moulding clips,
and then pry the mouldings to remove them in the following
order:
(1) Door drip moulding
(2) Door belt moulding
(3) Door window rear sash moulding
9. REMOVAL OF FRONT DOOR GLASS
(1) Turn on the ignition switch and operate the windows.
Be sure to turn the ignition switch off after finishing.
(2) Remove the door glass stabilizer.
(3) Remove the glass mounting nuts.
(4) Pull the glass upward and remove it.
.lO. REMOVAL OF POWER WINDOW REGULATOR
(1) Remove the door glass guide..