Chrysler Conquest 1988 Service Manual page 85

BODY - Windshield
23-57
Glass holders
'/ '
\
18Y55E
(2) From inside the vehicle, insert one end of wire through
adhesive at the upper edge of the windshield.
(3) Insert the other end of wire from inside the vehicle
through adhesive at the lower edge of the windshield.
(4) Secure each end of wire to a wooden handle or the like.
(5) Carefully cut through adhesive by pulling wire along the
windshield from outside the vehicle in a sawing motion.
Caution
In order to protect the body from damage, apply
cloth tape to all body areas around the installed
glass before cutting the adhesive.
(6) Make mating marks on the glass and body if the glass is
to be reinstalled.
(7) Take out the glass with glass holders.
NOTE
If the glass being removed is to be reinstalled, place it
on a protected bench or holding fixture.
(8) Use a screwdriver or similar tool to pry up and remove
the moulding clips.
INSPECTION
Check the moulding clips and studs. Replace them if they are
damaged.
NOTE
If a moulding clip stud has been broken, drill a hole of 3 mm
(.I 25 in.) in diameter in the stud, apply specified sealant to this
hole, and then install the moulding clip with a self-tapping
screw.
Specified sealant: Urethane adhesive (Essex Urethane "E"
Caution
. . . Auto Glass Sealant)
After installing the clip, apply antirust solvent to the screw
head and the clip to protect them from rust.
SERVICE POINTS OF INSTALLATION
15.-INSTALLATION OF WINDOW DAM
(1) Wipe surface of glass, to which bead of adhesive will be
applied [within 25 mm (1 in.) from the edge of glass]
with a cloth dampened in isopropyl alcohol.
Caution
Do not touch surfaces that have been degreased
with isopropyl alcohol.
Y18831