Chrysler Conquest 1988 Service Manual page 58

23-30 BODY -
Service Adjustment Procedures
S18641
S1864
4. Adjust the posrtron of the hatch latch
so that It
matches that
_
of the hatch striker.
DOOR FIT ADJUSTMENT
N23FEAi.I
1. Loosen the hinge mounting bolts on the body side, and
then move -the =door upward, downward, forward and
backward to adjust it so ~that the clearance around it is
equal. ~_
2. Loosen the hinge mountin&bolts of the door stde,-and then
_
move the door to the left and right to adjust the surfaces.
_
Caution
Attach protection tape to the fender edges near the
place where the hinge is installed.
3. Adjust fit between the front fender and hot-&door panel by
loosening the door side attaching bolts and_increasing or ;=;;
decreasing s&-r%.
4. Adjust engagement between the striker and~dooFlatch by, ;_
increasing or decreasing striker shims and/or sliding the 1
striker vertically or horizontally.
DOOR GLASS ADJUSTMENT
N23FFAE
1. Remove the-door trim and waterproof film. (Refer to ~_
P.23-64.)
2. Raise the door glass fulls and then adjust the following I
items so that the door glass fits evenly into the door glass
-
channel all the way around:
-
(1) Loosen the door glassmounting nuts, and then
adjust -
the door glass by moving it forward, backward, upward,
downward, and- to the left and right.
(2) Adjust the tilt of the door glass by tightening-the door -_
glass mounting nuts. =
INSIDE HAND/E PLAY ADJUSTMENT-
N23fGAD
1. Remove the door trim and waterproof film.
2. Move the mounting position of the inside handle longitudi- _
nally in order to adjust the play of the inside handle.
Standard value (A): 4 - 10 mm (.I6 - .39 in.)