Chrysler Conquest 1988 Service Manual page 73

BODY - Bumper
23-45
18Y945
8. Cover the back surface of the damage with a piece of
aluminum tape.
9. Prepare the adhesive, and apply it to the damaged area
using a spatula.
NOTE
If the damage is large, apply two coats of adhesive. Apply
the adhesive by moving the spatula from the edge of the
damaged area toward the center, so that the damaged area
will be filled with adhesive.
IO. After applying the adhesive, let it dry.
11. Polish the repaired area, using a double-action sander with a
disc.
NOTE
Sand repaired hole or cracks for about five minutes with the
disc.
12. Finish the surface of the repaired area with a hand sanding
block.
NOTE
The area should be carefully sanded so that there is no step
at the boundary line between the adhesive and the
undamaged surfacce coating.
13. To improve the grip of the paint, wet-sand the entire
surface of the bumper face while using #400-grit waterre-
sistant sandpaper and a rubber pad.