Chrysler Conquest 1988 Service Manual page 79

BODY
- Grille and Mouldinn
23-51
I & : Screws
18Y1743
Front quarter film
chipping protector
mm (in.)
18Y2062
T
3ear quarter film
:hipping protector
mm (in.)
18Y206
SERVICE POINTS OF REMOVAL
1. REMOVAL OF RADIATOR GRILLE
Remove radiator grille mounting nuts and clips and remove
the radiator grille.
3. REMOVAL OF FRONT DECK GARNISH
Using the trim stick, remove the front deck garnish by
prying at the clip positions.
5. REMOVAL OF AIR OUTLET GARNISH
Remove the air outlet garnish mounting nuts, and then
remove the garnish outward.
SERVICE POINTS OF INSTALLATION
7. INSTALLATION OF REAR QUARTER FILM CHIPPING
PROTECTOR / 6. FRONT QUARTER FILM CHIPPING
PROTECTOR
(1) Use lead-free gasoline to clean the mounting positions.
(2) After removing the paper protecting the back, .affix the
chipping protector at the correct location, paying heed
to the measurements shown.
Caution
1. The application should be done in a place with
little or no dust, and at an ambient temperature
of 20 - 40°C (70 - 100°F).
2. If the ambient temperature is below 20°C (7O"F),
warm both the chipping ljrotector and the body
FoppF;ation surfaces) to within 20 - 40°C (70 -