Chrysler Conquest 1988 Service Manual page 67

BODY
- Rear Hatch
23-39
.
18Y181C
16Y3608
NOTE
REAR HATCH SWITCH
(1) Unlock the rear hatch link.
(2) Check the continuity between the terminals.
Terminal
I
A
I
B
I
I
Rear hatch link locked
I I I
Rear hatch link unlocked
I -+- I
NOTE
C-O indicates that there is continuity,between the terminals
REAR HATCH KEY CYLINDER UNLOCK SWITCH
(I) Turn the key to unlock the lock cylinder.
(2) Check the continuity between the terminals.
O-O indicates that there is continuity between the terminals.
l
Check the rear hatch hinge for cracks and damage.
l
Check the rear hatch stopper for deterioration.
l
Check the rear hatch link assembly for wear, damage or
malfunction.
l
Check the rear hatch latch for wear, damage or malfunction.
l
Check the rear hatch striker for wear.
.
l
Check the rear hatch opening weatherstrip for cracks,
damage or deformation.
SERVICE POINTS OF INSTALLATION
23. INSTALLATION OF REAR HATCH LATCH / 22. REAR
HATCH LINK ASSEMBLY / 21. ROD SNAP
(1) Install the rear hatch latch.
NOTE
Be sure the rear hatch latch is unlocked.
Install the rear hatch link assembly1
(2) Install the left and right rods and secure them with the,
clip.
(3) Apply the specified grease to the moving parts of the
rear hatch link assembly and rear hatch latch assembly.
Specified grease: MOPAR Multi-purpose grease
Part No. 2932524 or equivalent
20.lNSTALLATlON OF REAR END TRIM / 19. TRUNK
ROOM SIDE TRIM / 17. SCUFF PLATE
Refer to P.23-95.