Chrysler Conquest 1988 Service Manual page 72

-.& .-.
23-44
18Y93;
Hole
9
IO-15mm
i.4 - .6 In.)
,
m .j; +$,,,
30-35 mm/
(I .2 - 1.4 in.)
URETHANE BUMPER REPAIR PROCEDURE
p -*- z-
--_ =
1. If the damage is a hole, use a knife or similar toolto shape -~
the hole into a round or-oval opening.
6:
YB
_
2. If the damage-is a crack orsplit, use a knife or similar tool to I z
widen the opening to approximately 2 mm (.08 in.).
3. G~rind the damaged area totapering shape of approximately -
IE
10 to 15 mm (.4 to .6 in,) in width with a sanding disc
(approx. #36[to #50).
.~
4. After initial grinding, the 3~ basic types of reparrs should be mi
m
as shown in the illustrations.
-.
=z
- rz:
=-
--~
-
5. Using a disc, remove the surface coatmg around the
damage, feather-edging the boundary line between the -r
finish and the urethane at the same time.
Try to feather-edge for 30 mm (I. 18 in.) around the damage. 1,
6. After feather-edging, the 3 basic types of repair should be =
as shown in the illustraiions.
7. Remove.anydirt adhering to the damaged-area wrth a rag ~1
soaked in benzine.
Caution
Do not use a lacquer-type thinner.