Deployment Cpu 013-Ccf0R00; Assembly; Start-Up Behavior; Addressing - YASKAWA CPU 013C Manual

For vipa system slio
Table of Contents

Advertisement

VIPA System SLIO
4

Deployment CPU 013-CCF0R00

4.1 Assembly

4.2 Start-up behavior

Turn on power supply
Delivery state

4.3 Addressing

4.3.1 Overview

4.3.2 Default address assignment of the I/O part

Sub module
Input address
AI5/AO2
800
802
HB300 | CPU | 013-CCF0R00 | en | 16-40
Information about assembly and cabling
mounting' on page 10.
n
The CPU checks whether a project AUTOLOAD.WLD exists on the memory card. If
so, an overall reset is executed and the project is automatically loaded from the
memory card.
n
The CPU checks whether a command file with the name VIPA_CMD.MMC exists on
the memory card. If so the command file is loaded from the memory card and the
commands are executed.
n
After PowerON and CPU STOP the CPU checks if there is a *.pkg file (firmware file)
on the memory card. If so, this is shown by the CPU by blinking LEDs and the firm-
ware may be installed by an update request.
The CPU checks if a previously activated VSC is inserted. If not, the SD LED gets on
n
and a diagnostics entry is released. The CPU switches to STOP after 72 hours. With
a just installed VSC activated functions remain activated.
entries' on page 89
After this the CPU switches to the operating mode, which is set on the operating mode
switch.
In the delivery state the CPU is overall reset. After a STOP®RUN transition the CPU
switches to RUN without program.
To provide specific addressing of the installed peripheral modules, certain addresses
must be allocated in the CPU. This address mapping is in the CPU as hardware configu-
ration. If there is no hardware configuration, depending on the slot, the CPU assigns
automatically peripheral addresses for digital in-/output modules starting with 0 and
analog modules are assigned to even addresses starting with 256.
Access
WORD
WORD
Deployment CPU 013-CCF0R00
Addressing > Default address assignment of the I/O part
Ä Chapter 2 'Basics and
Ä further information on page 81
Assignment
Analog input channel 0 (X4)
Analog input channel 1 (X4)
Ä Chapter 4.19 'Diagnostic
59

Advertisement

Table of Contents
loading

This manual is also suitable for:

013-ccf0r00

Table of Contents