Object Status - YASKAWA LonWorks SI-W3 Installation Manual

7 Network Variables
Member Name
■

Object Status

Output: FSNVT_obj_status nvoStatus
Shows the status of objects in a node.
Member
Name
object_id
bit 31 invalid_id
bit 30 invalid_request
bit 29 disabled
bit 28 out_of_limits
bit 27 open_circuit
bit 26 out_of_service
bit 25 mechanical_fault
bit 24 feedback_failure
bit 23 over_range
bit 22 under_range
bit 21 electrical_fault
bit 20 unable_to_measure
bit 19 comm_failure
bit 18 fail_self_test
bit 17 self_test_in_progress
bit 16 locked_out
bit 15 manual_control
52
14 RQ_REMOTE_CTRL
15 RQ_PROGRAM
0xff RQ_NUL
Object ID (refer to the object request)
Turns ON if the object_id specified by nviRequest is invalid.
Turns ON if the object_request specified by nviRequest is invalid.
Indicates whether or not a given object is enabled for operation.
Turns ON when an object is disabled.
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Not supported. (Always 0)
Description
Not supported. (Returns message:
invalid_request.)
Not supported. (Returns message:
invalid_request.)
Not supported. (Returns message:
invalid_request.)
Description
YASKAWA TOEP C730600 93B LonWorks Installation Manual